NOVEC1230 GAS EXTINGUISHING SYSTEMS
Novec 1230 fire suppression systems 3M™
Novec 1230 fire suppression systems 3M™
Combats fires using the product Novec™ 1230. This extinguishing agent is particularly suitable for the protection of areas with electronic and electrical equipment and offers an economical fire protection solution especially for small and medium sized rooms.
Featured
Novec 1230 extinguishing agent lowers the temperature of the fire and thus stops the combustion reaction. This substance is highly effective but also non-aggressive. Rapid extinguishing of a fire in the exposure phase minimizes fire damage and avoids long downtimes or business interruptions.
Novec 1230 is not corrosive or electrically conductive, leaves no residue and can be easily removed from the area of interest by means of ventilation. Novec 1230 is the preferred fire extinguishing agent for electronic and electrical risks where inert gases can also be offered as a solution.
Novec 1230 fluid has the best environmental properties compared to other gaseous chemical extinguishing agents. It does not pose any danger to the ozone layer and has a very low global warming effect. It dissipates completely in just five days.
Tek Bölgeli Söndürme Sistemi (Single-Zone System)
A single cylinder is usually sufficient to protect smaller rooms.
Smoke detectors constantly monitor the extinguishing zone and in case of fire send a signal to the fire detection and extinguishing control panel. In the case of single cylinder systems, the control panel opens the solenoid valve of the extinguishing agent cylinder to release the extinguishing agent into the piping.
It also transmits a signal to a permanently manned station. After a predetermined warning period has expired, the extinguishing process begins: The extinguishing agent is transported through the piping to the extinguishing zone within 10 seconds.
Multi-Zone System
Multi-zone systems are very similar to single-chamber systems, but they must use a common stock of extinguishing agents to protect all rooms.
In the event of a fire, the fire detection and extinguishing control panel controls specific selector valves. These valves release the extinguishing agent only to the fire extinguishing zones affected by the fire. The required amount of extinguishing agent is always calculated according to the largest protected area. If a smaller area is affected by the fire, only as much extinguishing agent is released as is necessary to extinguish the fire in that area. Due to the reserve of the extinguishing agent, the extinguishing capacity of the system is guaranteed even after the fire extinguishing system is triggered, ensuring uninterrupted operation.
Usage Areas
Server and IT Rooms
Data Archives
Control Rooms and Stations
Instrumentation Rooms
Electrical Switch Rooms
Switchgear and Distribution Panel Rooms